We’ve just posted a new firmware version to mynah.groovesizer.com (see the Firmware tab).

New features:

1. Tap tempo. To use, switch to BPM mode with F8+A8. While in BPM mode, continue to hold F8 and tap the desired tempo on A8
2. Value locking with pickup for Voice Boost and Comp Drive. To prevent sudden jumps in audio level when these values are adjusted, the potentiometer now first has to pass through and below the current value before the value can be adjusted.
3. Show an edit icon when adjusting per-step parameters. It could be confusing to know whether you are editing a parameter for an individual step or all steps. Now, when holding individual step buttons and adjusting with the potentiometer, or holding F1 and recording automation, an edit icon is shown as a reminder. It also helps to clarify which parameters are automatable and which are not.

Bug fixes:

1. Sticky Bounce mode. After switching to Bounce mode, it could take multiple presses to exit to another mode.
2. When adjusting per-step parameters, show the new parameter until F1/F8 is released.  Previously, the display would return to showing the per step parameter as the playhead passes over it once the pot locked.
3. Show parameter values consistently, rather than show alerts with new values for only some modes. There was some inconsistency in how parameter values were displayed with some displaying on the mode page, and some showing an alert with the new value.