Notifications
Clear all
19 hours ago
Replied to the topic the top 2 row buttons are not working
hi no luck, i will try again when i get some flux next week.
i have a concern with the PCM5102 Module 'cause when I soldered that I did not have the right clippers and so may have not trimmed enough, looking at board there seems to be a gap between these pins and the SD card module but if not woul…
21 hours ago
Created the topic AcidBoxMynah V1.1 in Firmware Support [AcidBoxMynah]
This update adds MIDI clock and pattern sync capabilities to allow either the AcidBoxMynah or the original version Mynah to sync to the other.There's also an new Sweep part (press F7 once to enter) with some preset sweep effects that may prove useful when recording or performing. This part can't be …
21 hours ago
Created the topic Firmware V1.3 in Firmware Support [Sampler]
This update contains a small delay on startup to make sure the power-rail has stabilized. It aims to prevent some weird behavior where the device will only start up when connected to USB power, but after that will run fine on batteries.
There are also a few small but important changes for improved…
1 day ago
Replied to the topic the top 2 row buttons are not working
Hey Navs, This sounds like a soldering issue with the shift registers ICs (see step 15 in the build in structions). Each row has its own 74HC165, but they all connect to the MCU on the same line – if one row works, it means the connection is fine. Resolder/reflow the pins on those shift registers an…
1 day ago
Reacted to a post in the topic the top 2 row buttons are not working
2 days ago
Created the topic the top 2 row buttons are not working in Hardware Discussion & Issues
would this be a case of resoldering or is fault elsewhere? the bottom row buttons work, thanks for any tips
2 days ago
Replied to the topic blue light flashing by usb port?
so the blue light flashing is the ESP32 chip indicating no battery attached; the continuous red light is the PCM5102 dac power on status
3 days ago
Replied to the topic blue light flashing by usb port?
i should add i also have a red light by the headphone port? i dont see those lights on Floyd Steinbergs video; I am on firmware 1.0
3 days ago
Created the topic blue light flashing by usb port? in Off-Topic / General Chat
hi
i have a blue light flashing when powering via usb, is this normal?
thanks
3 days ago
Replied to the topic Firmware V1.2
@navs No worries. I'll add a note about it somewhere .