Mac Users ?

Home Discussions General Mac Users ?

This topic contains 2 replies, has 2 voices, and was last updated by  Bob_Hart 2 years, 3 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2958

    Blancman
    Participant

    Hi all.. I am the only one using a Mac with my Groovesizer MB ??? Surely Not !
    Any help with getting me to understand how to change firmware via OSX would be much appreciated …. thanks in anticipation.

    Regards Phil

    #3334

    Bob_Hart
    Participant

    Hi, I use an iMac. You need to download the Arduino IDE software DMG from the Arduino web site, http://www.arduino.cc/en/Main/Software, and then download and install the libraries that moshang references on the firmware page. If you’re new to Arduinos, it would probably be a good idea to look through the learning portion of their web site to understand how to install and use the software. I can tell you it works fine, I just built a TB2 from the design files and loaded the firmware into the unit from my Mac. Hope this helps.

    Bob Hart

    #3335

    Bob_Hart
    Participant

    Sorry, I just realized after posting this that this was for the MB, not the TB2. Not sure what you need for that one, although the page for it says he integrated the Arduino (ATmega328?) into the board, so I’m guessing that you still need the IDE to load the firmware.

    Bob Hart

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.