File downloads:
Firmware – checked to work with latest Arduino IDE 1.5.8 BETA
Libraries required for the firmware to compile:
SD card image with Adventure Kid wavefiles and some patches:
Build sequence I used:
- resistors & diode
- 1/8″ mini jack & 8 pin socket
- SD socket
- LED
- Due headers
- 10K trimpot
- LCD (first solder 16pin header onto LCD and then solder LCD with header to the board)
- MIDI dins
- buttons
- pots
Here are some close-ups to help with the build:
For soldering the SD card, I start by soldering a small blob of solder on the pad marked in red, then placing the SD card slot and affixing it at that point (making sure the other pins line up). Then soldering the other large pad opposite it, and finally the connector pads.